Boat water installation repair-Boat-yat

View Full Screen
Document at bottom of page will appear blurry at first, if you wait a bit it will become clear.

Boat and yacht : Before assembly, all kinds of foreign substances in the installation (sand, filth, etc.) are cleaned. First First, one side of the valve is connected to the installation. Then the other side of the tensile tension It is connected to the installation without giving opportunities. Sealing Gasket Between Valve Flang and Plumbing Flang konur. It should not be above 2 meters from low water levels. Hydrophores to the place where it will be installed It should be firmly connected from its feet and there should be enough space for maintenance. Hydrophole is hot-cold of the water taken from the tanks on the right and left of the ship. It should be connected to other usage units before the separation points. Serial installation on board If the pipe is used, 2 short in connections to prevent the spread of the pump sound Hose should be used. The distribution installation is connected to the upper output, the pipes are as much as possible should be done short and flat